Table of Contents
Advertisement
Available languages
Available languages
5.
Remove bracket
Remove the screws (not the anchors) in order to remove the
■
bracket.
6.
Drill center hole
Drill an 8 mm hole where the center hole is marked and insert
■
1-8 mm anchor.
7.
Mount charcoal filter bracket
Place the charcoal filter bracket back into position so that all
■
the holes are aligned with the anchors.
Secure 2 screws on the upper bracket slots and one screw
■
with a flat washer on the lower bracket slot, to secure the
bracket in position.
10
Prepare for Installation
1.
Ensure grounded 3 prong outlet capable of 120 V, 60 Hz is
■
available before proceeding.
Ensure at least
■
charcoal filter bracket to top of the grounded 3 prong outlet.
Ensure at least 1
■
the bottom of the grounded 3 prong outlet.
Ground 3 prong outlet must be
■
than the chimney width.
2.
Remove grease filters before proceeding.
■
3
Verify electrical outlet location
120 V, 60 Hz
/
" (1 cm) gap between bottom of the
2
5
/
" (3 cm) gap between anchor screw and
9
50
/
" (2 cm) shorter in width
4
5
Remove grease filter
Advertisement
Table of Contents
