2703593_rev1_Mise en page 1 17/07/2013 16:58 Page 35
Mountings
Switch off the mains power
before handling the device.
• Lift off the cover by using
a screwdriver.
• Separate the programmer
from its base by loosening
the clamp screw
(captive screw).
• Secure the base with
3 screws and pegs or on
a flush mounted box
(distance between centres
60 mm).
Note: the base must be secured using 3 screws.
Note: To protect the power supply to the PLC
programmer, you must use a 10 A circuit breaker at
least (do not use a 2 A circuit breaker).
1
- 34 -