Code 3 CZ6015 Installation And Operation Instructions Manual page 4

Reapplication:
Clean the bottom of the mounting feet with detergent and water, removing any remnants of VHB or any other material. Prepare the surface
by wiping with isopropyl alcohol pads. Coat the area with the tape primer and allow the primer to dry thoroughly. The surface temperature
should be at least 50°F(10°C) but 70°F(21°C) is preferred. Remove the backing on one side of the VHB tape and adhere it to the foot of the
mount sub-assembly. See Figure 1. Leave the backing on the other side of the VHB tape for now. Repeat for the other side of the foot and
for the other three mounting feet. Follow steps 1-5 for vehicle installation.
Figure 1
Page 4 of 5