Next steps
1. Install the
hard-disk drive and optical-disk drive module
2. Install the
2.5 in. hard drive
3. Install the
Front bezel
4. Install
theSide cover
5. Follow the procedure in
System fan
Removing the system fan
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
front
bezel.
4. Remove the
2.5 in. hard drive
5. Remove the
hard-disk drive and optical-disk drive module
About this task
The following images indicate the location of the system fan and provide a visual representation of the removal procedure.
Steps
1. Disconnect the fan cable from the connector on the system board.
2. Slide the fan grommets towards the slot on the back of the fan chassis.
3. Lift the system fan from the system.
Installing the system fan
Prerequisites
About this task
The following image indicates the location of the VR heat sink and provides a visual representation of the installation procedure.
Steps
1. Align and place the system fan in the system chassis.
2. Pass the grommets through the chassis and slide outward along the groove to secure it in place.
3. Connect the system fan cable to the system board.
Next steps
1. Install the
hard-disk drive and optical-disk drive module
2. Install the
2.5 in. hard drive
3. Install the
front
bezel.
4. Install the
side
cover.
5. Follow the procedure in
48
Disassembly and reassembly
assembly.
After working inside your
before working inside your
assembly.
assembly.
after working inside your
computer.
computer.
.
computer.