Advertisement
Using the Inputs
Inputs 1 2 & 3 - Automatically Reset
Inputs 1 2 & 3are triggered by a negative pulse eg: pulled to the ground for a period of not less than one
second. The image (at the bottom of the page) 1s a typical application of how to connect the unit to an
alarm panel.
Input 1 and Input 2 are constantly monitored by the auto dialler and will react immediately when an input
is pulled to the ground. The inputs will automatically reset when the input triggers are cleared/ reset. The
Auto-Dialler will then be ready for the next trigger input.
Alarm Input - Manual Reset
Alarm Input
This is triggered by a negative pulse eg: pulled to the ground for a period of not less than one
second. Before this can be triggered you must activate the alarm input by sending the text
command as follows. The units will need manually activating again once triggered by a text
message.
#ALARM=ON#
- This will activate the alarm if the input is pulled to the ground. You will
receive a text message reading ALARM TRIGGERED
#ALARM=OFF#
- This will deactivate the alarm. Pulling the input to the ground will mean you
will receive NO notifications.
Page 9
Advertisement
