Advertisement
The Microprocessor will scan the temperature parameters every 3 minutes, when the temperature
goes outside of the temperature parameters this will generate a text alarm sent to the users indicating
the current temperature and turn on relay 1.
When the temperature returns into the temperature parameters, a text will be generated to let users
now temperature is normal, and relay 1 will be turned off
Text Commands
#+09*20#
This will save the parameter settings for plus 9 degrees to plus 20 degrees
#-10*20#
This will save the parameter settings for minus 10 degrees to minus 20 degrees
*NOTE YOU CANNOT MIX MINUS AND PLUS TEMPERATURES - PLEASE USE + OR - SYMBOL
#START#
will start the temperature reading / temperature alarm
#STOP#
will stop the temperature reading / temperature alarm
*Note In the event of a power loss the unit will remember if it was in stop or start mode
#TEMP#
at any time you can text this to get a temperature reading
Controlling The Temperature
Page 11
Advertisement
