Advertisement
The 4G Auto Dialler Plus has four inputs for a connection to electrical equipment plus separate
hardware for temperature, mains failure and external sensing. When these are triggered the
unit will call or text up to 3 separate numbers which can be stored on to the unit.
To programme the numbers you want to use, follow the examples below by sending the text
message command to the simcard in the auto dialler.
NOTE - We have colour coded the symbols hash (#) and (=) to make programming easier.
To programme the mobile numbers please follow this example:
#PH1=07712345678#
#PH2=01903123456#
#PH3=07123456789#
A maximum of 3 phone numbers in total.
To delete a stored number use the following example
#PH1=DELETE#
#PH2=DELETE#
#PH3=DELETE#
NOTE
Please send one message at a time and wait for the auto dialler plus to send you the text
Acknowledgement 'NUMBER STORED' before you try to send another number. This may take a
few minutes depending on how busy the network is at the time.
Programming Contact Numbers
- Stores the mobile/landline phone number as contact no: 1
- Stores the mobile/landline phone number as contact no: 2
- Stores the mobile/landline phone number as contact no: 3
-
YOU CANNOT DELETED NUMBER 1 - ONLY OVERRIDE
-
This deletes stored contact number 1
-
This deletes stored contact number 1
Page 6
Advertisement
