Flat panel cabinet cart with or without a pull out shelf (12 pages)
Summary of Contents for Bretford TC15SAFF
Page 1
TC15SA / TC15SAFF 19” RACK PRESENTATION CART WITH & WITHOUT POWER Assembly Instructions PARTS LIST Qty Part# Description 022-2820 Welded Body Assembly 022-2697 Left Door Assembly** 022-2698 Right Door Assembly** 010-1188 Door Stop Brackets** 022-2695 Top Shelf w/Grommet Hole 010-4785 Slide Brackets 030-1191 14” Full Extension Slides 010-4780 Keyboard Shelves 030-1206 Rack Rail Pair 010-4799 Rail Brackets 010-4867 Utility Shelves 015-0002 4” Casters w/o Brake 015-0003 4” Casters w/ Brake UCSE10 Electrical Unit - TC15SAFF ONLY ** Doors and stop brackets are attached to body assembly at the factory prior to shipping. Insert each caster into the bottom of each leg. If caster does not insert easily, use a rubber mallet to tap caster in place. Once caster are SECURELY in...
Page 2
MIDDLE SHELF ATTACHMENT BOTTOM SHELF ATTACHMENT STEP 2 Attach L-brackets to one side of the cart. These should be mounted on the side that you wish the 19” rack rails to be installed on. Attach each bracket (2 per shelf) with screws (AA) and nuts (BB) as shown. NOTE: Screws are only used on the bottom shelf. Middle shelf has screws already welded in place.
Page 3
MIDDLE SHELF ATTACHMENT BOTTOM SHELF ATTACHMENT STEP 3 Attach the rack rails to the L-brackets with screws (AA) and nuts (BB) as shown. The threaded holes (smaller) are facing out. NOTE, THE RACK RAIL MUST BE INSTALLED AS SHOWN. CORRECT INCORRECT TOP DOWN VIEW OF INSIDE CART...
Page 4
STEP 4 Separate each slide and attach outer slide piece (2 per bracket) to the slide brackets using screws (CC) and nuts (DD) as shown. NOTE: Slide may need to be extended some to align attachment holes. STEP 5 Attach each slide bracket above the middle shelf using screws (AA) and washers (EE) as shown. NOTE: Separate slides by pulling on black tab.
Page 5
Attach each inner slide piece to each keyboard shelf with screws (CC), washers (EE) and nuts (FF). Slide top shelf onto cart as shown. Secure all 4 corners with bolts (GG) and nuts (HH). Make sure shelf sides fit over the leg brackets and panel flanges. STEP 6 STEP 7...
Page 6
STEP 8 - FOR TC15SAFF MODELS ONLY Attach the UCSE10 unit to rear panel as shown using screws (II) and nuts (FF). STEP 9 Attach the utility shelves to the rack rails as shown with screws (JJ). NOTE: You can install the shelves in any desired location along the rails.
Page 7
STEP 10 Attach a handle to each door using screws (KK) as shown. STEP 11 Slide both keyboard drawers into the cart. Part # 031-7758 Rev. 07.01.08 CZ...