Flat panel cabinet cart with or without a pull out shelf (12 pages)
Summary of Contents for Bretford TC35FF
Page 1
1/4-20 x 1/2” Combo Screws #8-32 x 1/4” Truss Screws #8-32 Acorn Nuts #10 x 5/8” Phillips Pan Hd Screws 8-32 Hex Flange Nuts 8-32 x 3/8” Screws TC35FF ONLY Bottom Door Stop Plastic Handles Hex Wrench TOOLS REQUIRED Hex Wrench (Provided)
Page 2
STEP 2 Slide the 2 remaining lower legs onto the shelves as shown. Make sure the brackets are inside the shelves. CAREFULLY turn the unit on its back. Attach each side panel in the same manner as described in STEP 3 using bolts (AA) and nuts (BB) as shown. STEP 3 Slide the rear panel between the middle and bottom shelf so that the top flange is behind the leg brackets...
Page 3
STEP 5 Push casters into the sockets of each leg. To ensure casters are secure in sockets, a rubber mallet may be used to tap casters in place. STEP 7 Attach the door handles using screws (EE). STEP 6 Attach door stop to bottom shelf using screws (CC) and nuts (DD).
Page 4
Separate each slide and attach outer slide piece (2 per bracket) to the slide brackets using screws (GG) and nuts (HH) as shown. NOTE: Slide may need to be extended some to align attachment holes. Lay top shelf down and slide upper legs into each corner as shown. STEP 9 STEP 10 NOTE: Separate slides...
Page 5
STEP 11 Slide each slide bracket down between legs as shown. Secure all 4 corners with screws (AA) and bolts (BB). NOTE: The flange on the slide bracket is positioned in front of the w-bracket on the leg. Slide upper assembly onto lower legs and secure together with screws (II).
Page 6
STEP 13 Attach inner slide piece to keyboard shelf with screws (GG) and nuts (JJ). STEP 14 Slide each keyboard shelf into each side of the cart. Part # 031-7451 Rev. 05.14.08 CZ...