Table of Contents
Advertisement
SEQUOIA_U.book Page 525 Friday, January 25, 2008 11:27 AM
Stowing the flat tire, jack and all tools
Lay down the tire with the outer side facing up, and install the
holding bracket.
Then secure the tire, taking care that the tire goes straight up
without catching on any other part, to prevent it from flying for-
ward during a collision or sudden braking.
Keep winding until three clicks are heard.
Stow the tools and jack securely.
After completing the tire change
n
The tire pressure warning system must be reset. (→P. 455)
When using the temporary spare tire
n
As the temporary spare tire is not equipped with the tire pressure warn-
ing valve and transmitter, low inflation pressure of the spare tire will not
be warned. Also, if you replace the temporary spare tire after the tire
pressure warning light comes on, the light remains on.
SEQUOIA_U_(L/O_0804)
5-2. Steps to take in an emergency
Firmly tighten each nut two or
three times in the order shown in
the illustration.
Tightening torque:
154 ft·lbf (209 N·m, 21.3 kgf·m)
*
: When used on aluminum
wheel, apply 97 ft·lbf (131
N·m, 13.4 kgf·m)
*
5
525
Advertisement
Table of Contents
