OXE 30-0101-200 Service Manual page 175

LOWER BELT REPLACEMENT
4.
Remove 4 bolts and washers (2).
Use two M6 Allen-screws (3) with rounded ends to remove the bearing
housing (1). Screw the bolts inwards in an alternating fashion, half a turn
each time, in order to keep a parallel motion out of the seat of the bearing.
5.
Check the O-ring, replace if damaged or worn.
6.
Remove shaving and foreign debris.
!
CAUTION
Ensure to remove any material shavings in order not to enter the lower
housing or remain in the gearbox.
7.
Lean the pulley downwards before removing it from belt and housing.
OXE 150/200 HP SERVICE MANUAL
175