Usb Communications - Ortur Laser Master 2 Pro User Manual

USB Communications

Your Ortur Laser Master 2 Pro primarelly communicates with your
computer via the USB Serial protocol. This protocol is agnostic of the
operating system with exception of android based operating systems.
If your computer Operating System is: Windows 7 or newer (either
32bit or 64bit); MacOs 10.11 (El Capitan) or newer and Linux 64Bit the Ortur
Laser Master 2 Pro should be automatically detected by the operating system of
your computer when plugging the USB Cable.
A few important notes regarding USB Serial protocol and USB connection in
general:
• Your USB cable will deliver to the Ortur Laser Master 2 Pro motherboard 5v,
up to 1.5Amps. This power is suficient to power up your motherboard, but not
suficient to engage your laser and steppers motors;
• The maximum lenght on a USB 2.0 cable by specifications should not exceed 5
meters, 16 feet;
• When in a very electrical noise envorioment is advisable to upgrade the USB
cable for a full shielded cable with ferrite inserts;
• The USB Cable of your Ortur Laser Master 2 Pro is a USB 2.0 Type A to B
cable (commonly known as a USB Printer Cable);
USB Drivers:
Although rarelly necessary, is possible that your Windows Operating system might
need instalation of drivers in order for your computer to fully identify the USB
connection as a Serial Protocol. In MacOs and Linux this should not be necessary.
Drivers can be downloaded at the following locations:
Windows 10 – Windows 8
STM Micro v1.5 32Bit -
STM Micro v1.5 64Bit -
Windows 7
STM Micro v1.5 32Bit -
STM Micro v1.5 64Bit -
No.1 Building, Ruijin Science and Technology Industrial Park, Changping, Dongguan 523558, Guandong Province, China
DOWNLOAD
DOWNLOAD
DOWNLOAD
DOWNLOAD
Dongguan Ortur Intelligent Technologies Co., Ltd.
https://ortur.tech/olm2pro
53