General Information; General Description; Index; Repair Procedures - Toyota Corolla 2004 Manual

HOW TO USE THIS MANUAL

GENERAL INFORMATION

1.

GENERAL DESCRIPTION

(a) This manual is made in accordance with SAE J2008.
(b) Generally, repair operations can be separated in the following 3 main processes:
1. Diagnosis
2. Removing/Installing, Replacing, Disassembling/Reassembling, Checking and Adjusting
3. Final Inspection
(c) This manual explains the 1st process of "Diagnosis" (found in the "Diagnostics" section), the 2nd pro-
cess of "Removing and Installing, Replacing, Disassembling, Installing and Checking, and Adjusting",
but the 3rd process of "Final Inspection" is omitted.
(d) The following essential operations are not written in this manual. However, these operations must be
performed in actual situations.
(1) Operations with a jack or lift
(2) Cleaning of a removed part when necessary
(3) Visual check
2.

INDEX

(a) An alphabetical INDEX section is provided at the end of the book as a reference to help you find the
item to be repaired.
3. PREPARATION
(a) Use of special service tools (SST) and special service materials (SSM) may be required, depending
on the repair situation. Be sure to use SST and SSM when they are required and follow the working
procedure properly. A list of SST and SSM is in the Preparation section of this manual.
4.

REPAIR PROCEDURES

(a) Component drawing is placed under the title where necessary.
(b) Non–reusable parts, grease application area, precoated parts and tightening torque are specified in
the component drawings.
Example:
Slotted Spring Pin
15 (155, 11)
Cylinder
N·m (kgf·cm, ft·lbf)
: Specified torque
z Non–reusable part
2004 COROLLA (RM1037U)
INTRODUCTION –
Filler Cap
Float
Reservoir Tank
z Grommet
12 (120, 9)
Piston
HOW TO USE THIS MANUAL
z Gasket
Boot
Snap Ring
Washer
Push Rod
Author :
01–1
0103I–08
Clevis Pin
Clip
Clevis
Lock Nut
N17080
Date :
4