Installation Steps - Philips EasyKey 7000 Series User Manual

Installation steps

The following installation steps only apply to right-handed doors. For
left-handed doors, please read [Pre-installation instructions] carefully
and make necessary adjustments.
Mark the hole for drilling with
1
drilling template and drill the hole
marked, then mount the mortise
into the hole and fasten it with
four mortise anchor screws.
Attention
Make sure the latch bolt stays inside
the door during installation.
Pass the cable through the hole
3
and then insert the square shaft
of the outside escutcheon to the
rotary hole on the mortise until
the outside escutcheon is close to
the surface of the door.
6
Install the connecting screw tubes
2
on the outside escutcheon, and
put the compressed spring and
square shaft accordingly into the
square shaft holes.
M6 connecting
screw tube
Wi-Fi
antennas
Attention
Please choose the proper square shaft
and connecting screw tube to suit your
door thickness.
Place the mounting plate against
4
the inner surface of the door and
fasten it with four M5 connecting
screws.
Escutcheon
cable
M5 connecting
screw tube
Mortise cable
Escutcheon cable
Wi-Fi antennas