Installation Steps - Philips EasyKey 7100 User Manual

Step 3 | Latch Bolt Direction Reversing
You can change the latch bolt direction according to different door opening
directions: outward bevel for inward opening and inward bevel for outward
opening.
Latch bolt
Attention
1. Choose different installation kit as per different door thickness range.
2. The default installation kit applies to door thickness of 38 to 60 mm. If the door thickness is not
within this range, please contact us.

Installation steps

The following installation steps apply to right opening doors. For left
opening type, please read the [Pre-installation Instructions] carefully and
complete those necessary reversing operations.
Use the drilling template to drill
1
the needed holes on the door
and mount the mortise into the
door.
6
Latch bolt reversing tailpiece
Directional screw
1. Push the reversing tailpiece upwards to the top.
2. Press the latch bolt into the mortise and rotate it
180 degrees. Then pull it out.
3. Push the tailpiece downwards to the bottom.
4. Change the direction of the screws as needed
(The directional screws must be fixed on the inside
of the door, namely towards the inner unit of the
lock).
Hook the upper and bottom
2
poles
inserted(This step is not required
when installing on the wooden
door).
when the mortise is