Philips EasyKey 7000 Series User Manual page 9

Put the compressed spring and
5
square shaft into the square shaft
hole of the inside escutcheon
accordingly.
Remove the deco
7
cover at the top and
press the button at
the bottom of rear
escutcheon to remove
the battery cover,
then fasten the rear
escutcheon with two
M6 mounting screws.
Attention
After finishing the strike installation, please check whether the smart
door lock can be used normally.
Mortise cable
Front escutcheon cable
Wi-Fi antennas
Please hide the extra cables in the
door hole or the inside escutcheon.
Put the deco cover
8
back, install the
lithium battery, and
install the battery
cover along with the
strike.
Insert the cable of both outside
6
escutcheon and mortise into the
corresponding sockets on the
inside escutcheon. Then insert
the square shaft of the inside
escutcheon to the rotary hole
on the mortise until the inside
escutcheon is close to the surface
of the door.
Attention
Check whether
9
the rotary knob,
mechanical key, and
all other components
work properly.
Mortise cable
connector
Escutcheon
cable connector
7