Eterna BH60BK Safety And Installation Instructions

LAMP REPLACEMENT:

• Switch off the electricity at the mains.
• Remove the guard & diffuser etc.
• Remove and replace lamp making sure that it is of the same type and wattage as stated on the label
within the fitting or shown below.
• Replace diffuser and guard making sure that the gasket is intact and correctly positioned.

REPLACEMENT LAMP TYPE:

Wattage: 40W
Supply Voltage: 230 V.
Size / Type: E27 GLS or suitable CFLi equivalent.

EVENTUALLY, YOU MAY WANT TO REPLACE THIS LIGHT FITTING:

When your product comes to the end of its life or you choose to update or upgrade it by replacing
it, please do not dispose of it with your normal household waste and please recycle where facilities
exist. When you need to dispose of this fitting you can check with your retailer or local authority
for suitable options. New regulations require the recycling of Waste from Electrical and Electronic
Equipment (European "WEEE Directive" effective August 2005—UK WEEE Regulations effective 2nd
January 2007). Environment Agency Registered Producer: WEE/GA0248QZ.

IF YOU EXPERIENCE PROBLEMS:

If your product is defective or develops a fault, please return it to the place where you bought it.
You can call our helpline for advice. The helpline will gladly give advice on any aspect of any Eterna
Lighting product but may not be able to give specific instructions regarding individual installations.
If in doubt, consult a qualified electrician.
120119-SM
HELPLINE:
• T: 01933 673 144
• F: 01933 678 083
• E: sales@eterna-lighting.co.uk
MAX 60W
IP44
Visit our website:
www.eterna-lighting.co.uk
SAFETY AND INSTALLATION INSTRUCTIONS
Model:
BH60BK
60W Bulkhead With Wire Guard
These instructions are provided as a guideline to assist you.
PLEASE READ THESE INSTRUCTIONS BEFORE USING YOUR NEW FITTING
PLEASE RETAIN FOR FUTURE REFERENCE

Pack contents:

1 x bulkhead fitting
1 x fixing kit
2 x heat resistant sleeving
3 x grommets