• 1/2" to 1" IMC Bending Attachment Group .......... 5 • 3/4" and 1" EMT Setup ................6–7 The SG4-854 also includes a length stop for fast setup of identical bends. Installing the Roller Support ........6 Installing a Shotgun Bending Shoe ......7 Safety Pendant Setup ............
SG4-854 Shotgun Shoe Group for 854DX Electric Bender IMPORTANT SAFETY INFORMATION SAFETY ALERT Always use safety glasses. Everyday glasses only have impact resistant SYMBOL lenses; they are NOT safety glasses. When using in dusty environment, use face or dust mask.
Page 4
SG4-854 Shotgun Shoe Group for 854DX Electric Bender IMPORTANT SAFETY INFORMATION • Conduit moves rapidly as it is bent. The path of • Inspect the bender before use. Replace worn, the conduit must be clear of obstructions. Be sure damaged, or missing parts with Greenlee replace- clearance is adequate before starting the bend.
SG4-854 Shotgun Shoe Group for 854DX Electric Bender Bending Attachment Group RIGID, IMC, and EMT Conduit not included 04034: 1/2" to 1" Rigid 1/2" to 1" IMC 3/4" and 1" EMT UPC No. 78-3310- Description 04027 Bending shoe 04028 Roller support unit...
SG4-854 Shotgun Shoe Group for 854DX Electric Bender Setup 2. Align the right plate of the support with the bender roller plate as shown in the steps below. Always use safety glasses. Everyday Step 1: glasses only have impact resistant lenses;...
7. Press and hold the CLEAR button for 3 seconds to make the pendant read “00”. 8. Using the supplied bending table for the SG4-854, bend the conduit until the pendant reads the appro- priate degree.
SG4-854 Shotgun Shoe Group for 854DX Electric Bender Operation BENDING CONDUIT 1. Plug the bender into a grounded 20 amp outlet. Refer to the 854DX bender instruction manual. Always use safety glasses. Everyday 2. Turn on the bender’s main power switch.
SG4-854 Shotgun Shoe Group for 854DX Electric Bender Operation (cont’d) LENGTH INDICATOR 5. Slide the stopper assembly onto the tube or bar until the stopper contacts the conduit and tighten Use the length stop accessory for fast setup of identical the clamp screw, as shown.
SG4-854 Shotgun Shoe Group for 854DX Electric Bender Illustrated Bending Glossary back-to-back bend — any U-shaped bend formed by two parallel 90° bends with a straight section of conduit or pipe between the bends. center-to-center distance — the distance between the successive bends that make up an offset or a three-bend saddle.
SG4-854 Shotgun Shoe Group for 854DX Electric Bender Bending Instructions STUB LENGTH 90° STUBS 1. Measure the length of the required stub. MARK 2 MARK 1 2. Refer to the Minimum Stub Length formula on the DEDUCT Deduct Table. The required stub must be equal to or longer than the Minimum Stub Length.
SG4-854 Shotgun Shoe Group for 854DX Electric Bender Illustration and Parts List 04034 SHOTGUN SHOE GROUP 1/2" to 1" IMC and Rigid 3/4" and 1" EMT Part No. Description 52074609 Shotgun shoe assembly ................1 52074610 Roller support ................... 1 52066771 Holding yoke assembly (includes 3 and 4) ..........