Important Safety Information - Greenlee SG4-854 Instruction Manual

Shotgun shoe group for 854dx electric bender
Table of Contents

Advertisement

IMPORTANT SAFETY INFORMATION

This symbol is used to call your attention to hazards
or unsafe practices which could result in an injury or
property damage. The signal word, defined below,
indicates the severity of the hazard. The message
after the signal word provides information for pre-
venting or avoiding the hazard.
Immediate hazards which, if not avoided, WILL result
in severe injury or death.
Hazards which, if not avoided, COULD result in
severe injury or death.
Hazards or unsafe practices which, if not avoided,
MAY result in injury or property damage.
Read and understand all of the
instructions and safety information
in this manual before operating or
servicing this tool. Refer also to the
854DX bender manuals, which are
listed under "Other Publications."
Failure to observe this warning will
result in severe injury or death.
Do not use this tool in a hazardous
environment. Hazards include flam-
mable liquids, gases, or other materi-
als. Using this tool in a hazardous
environment can result in a fire or
explosion.
Failure to observe this warning will
result in severe injury or death.
Greenlee Tools, Inc.
SG4-854 Shotgun Shoe Group for 854DX Electric Bender
SAFETY
ALERT
SYMBOL
Always use safety glasses. Everyday
glasses only have impact resistant
lenses; they are NOT safety glasses.
When using in dusty environment, use
face or dust mask.
Failure to wear eye protection could
result in serious eye injury from flying
debris.
Pinch points:
• Keep hands away from bending
shoe, rollers, and conduit when
bender is in use.
• Support conduit when unloading.
Conduit can become loose and fall
if not properly supported.
Failure to observe these warnings
could result in severe injury or death.
• Reduce the risk of unintentional starting. Make sure
switch is in off position before plugging in.
• Never leave tool running unattended. Turn power
off. Do not leave tool until it comes to a complete
stop.
• Disconnect tools before servicing and when chang-
ing accessories such as shoes, rollers, and the like.
Accidental start-up could result in serious injury.
Failure to observe these warnings could result in
severe injury or death.
• Never stand on tool. Serious injury could occur if
the tool is tipped.
• Do not overreach. Keep proper footing and balance
at all times.
Failure to observe these warnings could result in
severe injury or death.
3
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sg4

Table of Contents