Table of Contents
Advertisement
Operation
Always use safety glasses. Everyday
glasses only have impact resistant
lenses; they are NOT safety glasses.
When using in dusty environment, use
face or dust mask.
Failure to wear eye protection could
result in serious eye injury from flying
debris.
Pinch points:
Keep hands away from bending shoe,
rollers, and conduit when bender is in
use.
Failure to observe this warning could
result in severe injury or death.
Wear proper apparel. Do not wear loose clothing,
gloves, neckties, rings, bracelets, or other jewelry
which may get caught in moving parts. Nonslip foot-
wear is recommended. Wear protective hair covering
to contain long hair.
Failure to observe this precaution may result in injury
or property damage.
Greenlee Tools, Inc.
SG4-854 Shotgun Shoe Group for 854DX Electric Bender
BENDING CONDUIT
1. Plug the bender into a grounded 20 amp outlet.
Refer to the 854DX bender instruction manual.
2. Turn on the bender's main power switch.
3. Press UNLOAD on the pendant until the shoe
grooves for the desired conduit size and type are
adjacent to the rollers.
4. Install the shoe hook into the two mounting holes,
as shown.
Install
holding
yoke into
mounting
holes.
5. Load the conduit so that the bending mark is
aligned with the front edge of the holding yoke, as
shown.
Align bending
mark with
front edge of
holding yoke.
6. Refer to the "Bending Instructions" section of this
manual or the Scale Reading Tables decal on the
bender for the appropriate bend scale reading.
7. Bend the conduit. (Refer to "Pendant Setup" for
button instruction.)
8. Press UNLOAD to rotate the shoe backwards
approximately 10° to remove the load on the hook.
9. Remove the holding yoke and conduit from the
shoe.
10. Press and hold UNLOAD until the shoe has rotated
back to the load position.
8
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Rotate shoe
until desired
grooves are
adjacent
to rollers.
Advertisement
Table of Contents
