Table of Contents
Advertisement
As stated above, to access the Menus, press and hold the Menu Access
seconds until a menu label appears in the upper display. There are additional menus presented when an
MENU SYSTEM
option is selected under the Option menu; however, the options are non-functional unless the appropriate
OVERVIEW
option board has been installed.
Pressing the Menu Access
allows you to scroll along the top line of menus which are displayed in the top (red) window.
We recommend you
start with the INPUT
menu.
Pressing the Mode/Enter
in the lower (green) window.
The Raise and Lower
will alternate between the parameter and the parameter value.
(Input Menu)
Note - Parameter
labels displayed
will vary, depending
upon the controller
configuration.
This table is a
representation of
available parameters
within the different
menus. Please refer
to the relevant menu
descriptions.
MENUS
Display
18
key indexes from menu to menu. i.e. pressing the Menu Access
key indexes through the parameters in a particular menu; these are displayed
keys are used to modify the visible menu parameter value. The lower window
(Display Menu)
(Output Menu)
Menu
Input
Display
Output
Control
Alarm
Tune
Recipe
Supervisor
Calibration
Option
Communications
Contact/Digital Input
Remote Analog Setpoint
Auxiliary Output
(Calibration
(Alarm Menu)
(Tune Menu)
Menu)
Description
Used to select sensor-related parameters, such as input type, limits, and scaling.
Available at the
security level.
Used to set or change decimal position and display units. Available at the
security level.
Used to specify output usage, control methods, and alarms. Available at the
security level.
Used to select parameters associated with the control methods.
Available at the
security level.
Used to select alarm parameters . Note: This menu is also functional for
controllers not equipped with alarm hardware; however, alarm indication will be
only visual via the A1 and A2 LEDs on the front panel. Available at the
security level.
Used to set the autotune damping parameter. Available at the
level.
Used to set ramp and soak parameters. Available at the
Used to set fail-safe and supervisory parameters. Available at the
level.
Used to recalibrate input.
Available in the
(Option)
Used to set serial communications parameters.
security level;
available at the
Used to select switch input functions.
(Option)
level;
available at the
security level.
(Option)
Used to select switch input functions.
level.
Not Currently Available - for future use.
(Option)
Used to set auxiliary output parameters.
(Option)
security level.
key for approximately 3
(Recipe Menu)
(Supervisor
Menu)
security
security level.
security level.
Activated in the
security level.
Activated in the
Activated in the
Activated in the
key
(Calibration
Menu)
security
security
security
Advertisement
Table of Contents
