Operating Instructions; Vehicle Charge Ports And Vehicle Plugs; Control Unit - Porsche Wall Charger Connect Operating And Installation Manual

– On the charger: S > I
ETTINGS NFORMATION
– In the web application: S > M
ETTINGS
D
EVICE INFORMATION
Porsche ID
When the charger is paired to your Porsche ID,
information about the charger and the charging
processes can be displayed in My Porsche and in
the Porsche Connect app.
If you will no longer be using the charger,
e.g. if you sell it:
1. Unpair the charger from your Porsche ID
(S > U ).
ETTINGS SER PROFILES
2. Reset the charger to factory settings
(S > F
ETTINGS ACTORY SETTINGS

Operating Instructions

In some countries, the relevant authorities must be
notified when you connect electric vehicle charging
equipment.
e Check obligation to notify the authorities and
legal requirements for operation before
connecting charging equipment.
Damage to the charger
NOTICE
e Only operate the Wall Charger Connect when it is
mounted on the wall.
e Do not immerse or submerge the charger in water.
e Protect the charger from snow and ice.
e Handle the charger with care and protect it from
potential damage due to being driven over,
dropped, pulled, bent or crushed.
e The Wall Charger Connect housing may only be
opened for installation by an electrician.
NOTICE
>
AINTENANCE
The charger must only be operated within
a temperature range from –22 °F to +122 °F
(–30 °C to +50 °C).
e To prevent overheating during operation, avoid
continuous exposure of the charger to direct
sunlight. If the charger overheats, charging will be
interrupted automatically until the temperature
has returned to the normal range.
e If the charger is too hot or too cold, let it return
slowly to the operating temperature range and do
not actively cool it down or heat it, e.g. by cooling
it down with cold water or heating it with
a hairdryer.
).
Vehicle Charge Ports and
Vehicle Plugs
Different vehicle charge ports A and vehicle plugs B
are available depending on country-specific vehicle
equipment.
Connection and plug

Control Unit

Damage to the charger
Fig. 2: Control Unit
A
B
C
Standard and designation The charger can be switched on and off using
the Power button A
IEC 62196-2/
The status LEDs B show the status of the charger.
SAE-J1772-2009
Communication with the charger takes place via the
Type 1 UL/IEC
display C. It shows information and error messages.
Operating Instructions
Power button
Status LEDs
Display
US
FC
ESM
7