Lennox LI009CI-160T432 Service Manual page 105

Step
6.remove the soundproof sponge.
Tear off the sticking stripe and then remove the
soundproof sponge.
7.remove the isolation plate and reactor
Remove the 2 screws connecting the isolation
a
plate and condenser side plate; remove the
3 screws connecting the isolation plate and
chassis, and then remove the isolation plate.
Remove the 4 screws connecting the reactor
b
and isolation plate, and then remove the reactor
102
Procedure
soundproof
sponge
screw
isolation plate
screw
reactor
sticking
stripe
screw(Note: these two screws are
at the side of motor support)
Installation and Maintenance
Service Manual
screw