Advertisement
Free VEnd Coupons and Bill programming
Follow the same process to program the Talos with bills or free vend coupons, but note that the
LED codes are slightly different:
Flashes
Meaning
10
The bill or vend coupon has been enabled successfully
7
The bill validator was unable to read the bill or vend coupon. Try again.
3
The bill or vend coupon has been disabled
Other Documentation
All support documentation, including a downloadable copy of this coupon, can be found
at Cranepi.com/support.
Scan
Log in
Tap Support
Tap
Tap
Add a Product
View Downloads
Then
Then
Use the filters
Choose your
or scroll to find
Document
And select
Talos
My Library
Coupon Sections
Section 1 - bill ways
1 - Face up in one direction (green seal
first)
2 - Face up in either direction
4 - Face up or down in either direction
Section 2 - Bill enables
Fill in on or off to enable or disable a
bill.
$50 and $100 - T8 Models Only
Fill in on or off to enable or disable a
bill.
Section 3 - Pulse Width
Sets the width of the pulse, check with
your machine manufacturer for details.
Section 4 - Pulses Per Dollar
Credit pulses per dollar accepted,
check with your machine manufac-
turer for details.
Section 5 - Interface mode
Harness Enable - requires an input
from the controller to enable and accept
bills.
allows for
Always Enable -
acceptance at all times, a host or
controller cannot disable the unit.
Section 6 - Acceptance mode
Mode 0 is default. Increasing
Acceptance Mode increases security,
but may also impact performance.
Please contact CPI Technical Support
for details.
Print actual size
66mm
Cut carefully on the dotted line. The coupon
should be the same size as an American bill when
complete.
Advertisement
