Download Print this page

aidapt VA140 Fitting And Maintenance Instructions page 2

Channel ramps

Advertisement

Available languages

Available languages

CAUTION!
Always risk assess any situation for any possible risks.
Only use these ramps with a qualified helper, never exceed the recommended
weight limit during use.
Always back the wheelchair/scooter down the ramps and use a lap strap for safety.
Always check the wheelchairs/scooters owners' manual regarding the safe incline
for any particular chair.
N.B. This equipment must be installed by a competent person.
VA140
VA147
Weight Capacity 200 kg using both ramps (100 kg per individual ramp)
Do not exceed the weight limit stated – doing so could put the user at risk.
USING YOUR RAMP
Always fully extend the ramps before use to minimize the risk of injury, and
also make any ascent or descent using the ramps easier.
Select a place to use where the ramps have the minimum gradient
possible. Ensure the gradient of the ramps is not beyond the ability of the
wheelchair or occupant.
Place the narrow end of the ramp on the ground or low point, and place
the wide end of the ramp on the vehicle or high ground.
Ensure the ramps are safe before use.
If available, use the two cords included to check the two ramps are parallel
and the width is suitable for the width of the wheelchair or scooter.
TO EXTEND
Slowly pull out the narrowest section of the ramp whilst holding the
widest section, until it is locked in position.
To extend the ramp to its full length, continue to pull the narrowest
section of the ramp whilst pressing button situated upon the outside of
the ramp. Do this until the section is locked in position.
Repeat this for the other ramp.
Usage and Maintenance Instructions
5ft Channel Ramp
7ft Channel Ramp
2
Ver. 1 Jun. 2012 (1258)

Advertisement

loading
Need help?

Need help?

Do you have a question about the VA140 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

This manual is also suitable for:

Va147