Page 3
Safe recovery instructions Description of climate types his product contains a light source of energy efficiency class F for light source ERP, test with(without) light cover...
This refrigerating appliance is not intended to be used as a built-in appliance >L1+100 >W1+200 >L1+450 >W1+450 Preparations prior to use 1. Remove all packing assemblies such as case fixing tape etc., especially the foam base. 2. Use warm wet cloth to clean both interior and exterior of the refrigerator, (neutral detergent can be added in warm water).
The appliance should be located in the coolest area of the room, away from heat producing appliances or heating ducts, and out of the direct sunlight. Let hot foods cool to room temperature before placing in the appliance. Overloading the appliance forces the compressor to run longer.
Page 11
First power-on After first power-on, the refrigerator shall operate with the cold chamber set at 5℃and the freezing chamber set at -18℃. Hand temperature regulating function When no button on the display panel is operated within 30s, the display panel will go out, and the keyboard will be locked automatically.
Page 12
Smart function When the display panel is unlocked, press the Function button repeatedly until the “ ” icon flashes, and then stop operating any button and wait for 5s to activate the smart function. Such operation can quit the smart function by hand. After the smart function is activated, the refrigerator can monitor the state of each chamber and operate with the highest efficiency.
Page 14
Changing the Light Any replacement or maintenance of the LED lamps is intended to be made by the manufacturer, its service agent or similar qualified person.
Page 17
Safe recovery instructions Disposal Old appliances still have some surplus value. An environmentally friendly approach will ensure that valuable raw materials are recycled. The refrigerants used in your equipment and insulation materials require special handling procedures. Make sure there is no pipe damage on the back of the equipment before handling. Up-to-date information on the options for disposing of old equipment and packaging from old equipment can be obtained from the local municipal office.