Table of Contents
Advertisement
Safety Information, Instructions, and Symbols
Safety Information
Classification
The unit consists of an exposed metal chassis that is connected directly to earth via a power
cord and, therefore, is classified as a Class 1 instrument. Class 1 refers to equipment relying on
ground protection as a means of shock protection.
The following symbol is used to indicate a protective conductor terminal in the unit.
Disconnecting from Line Power
Some of the circuits are powered whenever the unit is connected to the AC power source (line
power). To ensure that the unit is not connected to the line power, disconnect the power cord
from either the power inlet on the unit's rear panel or from the AC line-power source
(receptacle). The power cord must always be accessible from one of these points. If the unit is
installed in a cabinet, the operator must be able to disconnect the unit from the line power by
the system's line-power switch.
Line Power Requirements
The unit can operate from any single-phase AC power source that supplies between 100 and
240 V at a frequency range of 50 to 60 Hz. The maximum power consumption is 100 VA.
Fuse Type
The fuse type used by the unit is (5x20) mm, T1A/250 V (slow).
Laser Application
Warning
The unit is rated as a system for use with laser equipment. The laser class of
any unit connected to the SCG unit applies to the SCG unit. Follow appropriate
laser safety procedures for that class.
Safety – 1
Advertisement
Table of Contents
