Advertisement
queue. The ERROR line is driven low when the errors are read out of the error queue or
the error queue is cleared.
Power Interface
The SKB switch is powered through a single 4 pin connector. The pin assignment is
shown in Table 3. In the case of SK emulation, the power connector is not necessary
when there is less than 8 inches of cable.
Table 3: Phase II Power Pin
PIN
SIGNAL
1
-
2
GND
3
NC
4
+5V
Connector Information
The connector on the SKB switch is an IDE, 50(2x25) male + 4 male power, PCB, edge-
mount connector, (Comm Con P/N 7514).
The recommended mate for SKB operation is an IDE, 50(2x25) female + 4 female power,
right angle connector (Comm Con P/N 7510).
The recommended mate for SK emulation is a 2x13 female ribbon connector.
For details on pin numbering and connector dimensions, please refer to Figures 1 and 2
respectively. For further information about connector specifications, please contact:
Comm Con Connectors, Inc.
1848 Evergreen Street, Duarte, CA 91010
Phone: (626) 301-4200 Fax: (626) 301-4212
Email:
info@commcon.com
Home Page:
http://www.commcon.com
10106094 Rev. 001
DESCRIPTION
Reserved
Ground
No connect
5 volts supply in
Page 5 of 7
Advertisement
