Setting The Gpib Address; Rs232C Pin Assignment - JDS Uniphase SCG Series User Manual

Table 7: GPIB Interface Functions
Mnemonic
SH1 Source handshake, complete capability
AH1 Acceptor handshake, complete capability
T6 Basic talker, serial poll, not addressed if MLA
L4 Basic listener, not addressed if MTA
SR1 Service request capability
RL1 Remote/local, complete capability
PP0 Parallel poll, no capability
DC1 Device clear, complete capability
DT0 Device trigger, no capability
C0 Controller, no capability
E1 Electrical interface, open collector drivers

Setting the GPIB Address

To set the GPIB address:
1. Press the GPIB ADDR key. The current GPIB address, appended with an asterisk, is
displayed. (The factory-set GPIB address is 7.)
2. Scroll to the required address using the
keypad.
3. Press the Enter key to activate the new address. To leave the GPIB address unchanged,
press a mode key (GPIB ADDR, Relay, or Channel).

RS232C Pin Assignment

Figure 16 shows the RS232 pin assignment, which is not applicable if expansion hardware is
installed.
Function
or key, or enter the address using the numeric
Figure 16: RS232 Pin Assignment
Programming Guide – 24