Installing The Ph Injection Heat Contactor - AQUALUX Dinotec Premium Installation, Use And Maintenance Manual

6.6. Installing the pH injection heat contactor

2
21
10
A
C .
1) Place the pH corrector container
equipment room's internal ventilation and as far away as possible
from any electrical device.
7
2) Connect the ballasted filter
the semi-flexible tubing
13
.A..and .B.).
3) Insert the ballasted filter
4) With the use of Teflon tape (not supplied), screw the injection
connector
21
I
connector 18), respect the direction of assembly of the parts, and
in particular the direction of the arrow engraved on the fitting.
15
Failure to follow these instructions can lead to the peristaltic
18
pump being damaged.
5) Connect the injection connector
with the semi-flexible tubing,
10
21
18 into the accessories holder
Following image .C..(exploded view of the injection
B .
18
2 as close as possible to the
10 to the peristaltic pump 13, with
to be cut to the right size (see photos
10 at the bottom of container 2.
15 and tighten by hand.
18 to the peristaltic pump 13,
21 to be cut as needed.
21
9