Table of Contents
Advertisement
8-Troubleshooting
Problem
Automatic adjustment
of washing time.
Spinning fails.
Unsatisfactory wash-
ing result.
Washing powder
residues are on the
laundry.
Laundry has grey
patches.
Note: Foam formation
If too much foam is inspected during spin cycle, motor stops and drain pump will be ac
tivated for 90 seconds. If that elimination of foam fails up to 3 times, programme ends
without spinning.
Should the error messages reappear even after the taken measures, switch off the
appliance, disconnect the power supply and contact the customer service.
8-4
23
Cause
Washing programme duration will
be adjusted.
Unbalance of laundry.
Degree of pollution does not agree
with selected programme.
Detergent quantity was not sufficient.
Maximum load has been exceeded.
Laundry was unevenly distributed
in the drum.
Insoluble particles of detergent can
remain as white spots on the laun
dry
.
Caused by fats such as oils, creams
or ointments.
8.4 In case of power failure
A
The current programme and its setting will be saved.
When power supply is restored operation will be re
sumed.
In case of power failure during programme run door
opening is mechanically blocked. If the laundry is to
be removed, the water level must not be visible in the
glass door. -Danger of scalding!
Lower the water level according to step 1 to 6 of
chapter CARE AN CLEANING (PUMP FILTER).
Pull lever (A) beneath service flap (Fig.8-4) until
door
Fix all parts and close the service flap.
Solusion
This is normal and doesn't af-
fect functionality.
Check machine load and laun-
dry and run a spinning progra-
mme again.
Select an other programme.
Choose the detergent accord-
ing to the degree of pollution
and according to manufacturer
specifications.
Reduce loading.
Loose the laundry.
Perform extra rinse.
Try to brush the points from the
dry laundry
Choose an other detergent.
Pretreat the laundry with a spe
cial cleaner.
i
s unlocked by a gentle click.
.
Advertisement
Table of Contents
