Table of Contents
Advertisement
7-Care and cleaning
7-5.1
Note: Hygiene
After long periods of disuse we recommended to run programme Drum Clean with
no load and small amount of detergent in washing agent compartment (2) or special
machine cleaner to remove possibly corruptive residues.
7-6.1
7-6.3
7-6.5
19
7
.5 Long periods of disuse
7-5.2
If the appliance is left idle for a longer period:
1. Pull out the electrical plug (Fig. 7-5.1).
2. Turn of water supply (Fig. 7-5.2).
3. Open the door to prevent formation of moisture
Before next usage check carefully power cord, water
inlet and drain hose. Make sure everything is properly
installed and without leakage.
7-6.2
7.6 Pump filter
Clean the filter once a month and check the pump
filter
Scalding Risk! Water in the pump filter can be very
7-6.4
hot! Before any action please ensure water has co-
oled down.
1. Turn of and unplug the machine (Fig. 7-6.1).
2 . Open service flap. You can either use a coin or a
3. Provide a flat container to catch leach water
4. Pull the drainhose out and hold its end above the
7-6.6
5. Take the sealing plug out of the drainhose (Fig.
6. After complete drainage close drainhose (Fig.
7. Unscrew and remove counter clock wise the pump
8. Remove contaminants and dirt (Fig.7-6.6).
and odours. Let door open while not used.
f
or instanvce if the appliance:
Doesn´t drain the water.
Doesn´t spin.
Cause unusual noise while running.
WARNING!
screw driver (Fig. 7-6.2).
(Fig. 7-6.3). There could be bigger amounts!
container (Fig. 7-6.3).
7-6.3).
7-6.4). and push it back into the machine.
filter (Fig.7-6.5).
Advertisement
Table of Contents
