Brother MFC-890 Quick Setup Manual page 8

Step 1
7
Gently insert the black ink cartridge in the
black ink position.
8
Press the cover down until it clicks.
9
Repeat Steps 5 to 8 to install each colour ink
cartridge. Match the colours of the ink
cartridge covers.
0
Close the scanner cover. The machine will
enter a head cleaning cycle for
approximately six minutes.
CLEANING
PLEASE WAIT
6
Setting Up the machine
• DO NOT remove ink cartridges if
you do not need to replace them. If
you do so, it may reduce the ink
quantity and the machine will not
know the quantity of ink left in the
cartridge.
• DO NOT shake the ink cartridges. If
you do so, the ink may spill when
you take off the sealing tape. If ink
stains your body or clothing, wash
with soap or detergent
immediately.
• DO NOT refill the ink cartridges.
Attempting to use refilled
cartridges and using incompatible
inks may cause damage to the print
head in this machine and such
damage will not be covered by
warranty. Warranty coverage does
not apply to problems caused by
the use of 3rd party ink or 3rd party
ink cartridges. Use only genuine
Brother ink cartridges.
If you mix the colours by installing an ink
cartridge in the wrong colour position, you
must clean the print head several times
after correcting the cartridge installation
and before you start printing.
Once you open an ink cartridge, install it in
the machine and use it up within six
months of installation. Use unopened ink
cartridges by the expiration date written
on the cartridge package.
If shows on the LCD after you
INK EMPTY
install the ink cartridges, check to make
sure the ink cartridges are installed
correctly.