Connecting The Power Cord; Connecting To A Cable Radio Signal - Bose Wave radio Series III Owner's Manual

Connecting the power cord

Figure 3
Connecting the power cord

Connecting to a cable radio signal

1. Plug the small end of the power cord into the power jack on the back of your radio
(Figure 3). The connector is shaped to fit in only one direction. Line up the flat edge of the
plug with the flat edge on the side of the jack.
2. The FM antenna is built into the power cord. To improve FM reception, unwind the power
cord completely.
3. Plug the other end of the power cord into an electric outlet.
4. The display panel lights and the time display begins flashing.
5. Press the CLOCK SET button once to stop the flashing.
Flat edge
of connector
To connect your radio to the FM signal available from some cable TV companies, contact
your cable provider for assistance. The connection is made to the FM 75Ω EXTERNAL
antenna connector on the back of the radio.
CAUTION: Be certain that the installation includes a signal splitter so that only the FM band,
not the cable TV band, is transmitted to the radio. It is necessary to use a splitter that filters
the signal to prevent any re-emissions of the TV spectrum through the radio.
Setting Up
7