Connect The Power Cord And Antennas - Bose Wave Radio Owner's Manual

Setting Up

Connect the power cord and antennas

Find the jacks on the back of your radio (see Figure 3). Unwind all cords.
Connect the power cord
1. Plug the small end of the power cord into the power jack.
2. Plug the other end of the power cord into an electric outlet.
The display panel should light up.
Connect the antennas
1. Plug the FM antenna into the "FM 75 External" connector.
2. Plug the AM antenna into the "AM LOOP" jack.
3. Straighten both antennas. Move the AM loop and ends of the FM antenna as far as
possible away from the radio.
4. Use the clip and peel-and-stick tape to attach the AM loop antenna to a smooth, clean
surface, if you wish.
R L
AUX IN
VARIABLE OUT
6
120V~AC
AM
50-60HZ 50W
LOOP
172087
January 7, 2002
Note:
The time display will begin to flash
after power is connected. Press the
CLOCK SET key once to stop the
flashing.
Note:
A second FM antenna is built into the
power cord. For best reception,
adjust the antenna by moving the
power cord.
Figure 3
Plug the antennas and power cord
into their jacks.
Peel-and-
stick tape
clip
AM149204_02_V.pdf