ZyXEL Communications NWA Series User Manual page 213

The following table describes the labels in this screen.
Table 70 Configuration > System > SNMP
L ABEL
Enable
Server Port
Trap
Community
Destination
Trap Wireless
Event
SNMPv2c
Get Community
Set Community
SNMPv3
Add
Edit
Remove
#
User Name
Authentication
Privacy
Privilege
Apply
Reset
16.9.4 Adding o r Editing a n SNMPv3 Use r Pro file
This screen allows you to add or edit an SNMPv3 user profile. To access this screen, click the
C o nfig ura tio n > Syste m > SNMP
click the Edit
Chapter 16 System
DESC RIPT IO N
Select the check box to allow or disallow users to access the Zyxel Device using SNMP.
You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Type the trap community, which is the password sent with each trap to the SNMP manager.
The default is public and allows all requests.
Type the IP address of the station to send your SNMP traps to.
Select this to have the Zyxel Device send a trap to the SNMP manager when a wireless client is
connected to or disconnected from the Zyxel Device.
Select this to allow SNMP managers using SNMPv2c to access the Zyxel Device.
G e t C o m m unity
Enter the
from the management station. The default is public and allows all requests.
Se t c o m m unity
Enter the
management station. The default is private and allows all requests.
Select this to allow SNMP managers using SNMPv3 to access the Zyxel Device.
Click this to create a new entry. Select an entry and click
selected entry.
Double-click an entry or select it and click
To remove an entry, select it and click
it before doing so. Note that subsequent entries move up by one when you take this action.
This the index number of an SNMPv3 user profile.
This is the name of the user for which this SNMPv3 user profile is configured.
This field displays the type of authentication the SNMPv3 user must use to connect to the Zyxel
Device using this SNMPv3 user profile.
This field displays the type of encryption the SNMPv3 user must use to connect to the Zyxel
Device using this SNMPv3 user profile.
This field displays whether the SNMPv3 user can have read-only or read and write access to
the Zyxel Device using this SNMPv3 user profile.
Click Apply to save your changes back to the Zyxel Device.
Re se t
Click to return the screen to its last-saved settings.
screen's
button.
NWA/WAC/WAX Series User's Guide
, which is the password for the incoming Get and GetNext requests
, which is the password for incoming Set requests from the
Edit
to be able to modify the entry's settings.
Re m o ve . The Zyxel Device confirms you want to remove
Add button or select a SNMPv3 user profile from the list and
159
Add to create a new entry after the