Bosch DVR4C1161 Installation Manual page 17

DVR4C | Installation Manual | Menu system
• Fill in the IP, subnet mask and default gateway
addresses when DHCP is set to Off.
• Fill in the DNS in order to use an e-mail address. At
least one DNS should be specified.
• Set Auto-Detect to On to allow the Remote viewer
software to automatically detect the DVR in a
network.
> Auto-Detect may not work when a firewall is between the
DVR and the PC.
• Set the Bandwidth limit throttle to restrict the
network bandwidth used.
>>> DSL
X
• Specify the Username and Password for an xDSL
connection if required.
• When connected, the status shows Connected.
>>> HTTP PORT
• The DVR provides flexible network communication
port configuration. If the DVR is on a special
network, the HTTP port can be changed to the
appropriate number. For network communication
port information, ask your network administrator.
• The default is 80.
>>> COM PORT
• Configure the single RS-232 serial port for use with
either a text device or a PSTN modem.
• Select Device with the up/down keys.
• If a modem is selected, an initialisation command
can be entered.
• Select appropriate values for serial communication
for Baud rate, Parity, Stop bits and Data bits.
>>> PSTN DIAL-IN
• Remote users who have a PSTN connection via a
modem can access the DVR.
• If you select Use default IP, the DVR automatically
provides a pre-defined IP address (10.0.0.10) for the
client PC and 10.0.0.9 as its own.
• Select Custom to specify exact IP addresses for both
the DVR itself and the client PC.
>>> E-MAIL SETUP
The DVR can send an e-mail on a specified event.
• If Status is set to On, an e-mail is sent to the specified
address on an input alarm, videoloss or system
failure.
• Specify a recipient address and an e-mail sending
server (SMTP) address.
Bosch Security Systems | Version 1. 1
• Select the number of images to be sent attached to
the e-mail (3 JPEG images by default). The DVR
attaches 1 image per second. With a videoloss the
images just before the videoloss are attached. No
images are attached when a system failure occurs.
>> INPUTS AND OUTPUTS
Inputs and outputs can be configured in this menu as
Normally Closed (NC) or Normally Open (NO).
• Select either NC or NO with the up/down scroll keys.
Press the play key to confirm.
• Outputs have the following fixed purpose:
Item Purpose
Output 1 Activated only on
Input Alarm
Output 2 Activated only on
System failures
Output 3 Not assigned for local
control
Output 4 Not assigned for local
control
• Select Relay Dwell time ranging from 0 to 60 seconds
on the selection slider with Left/Right scroll keys and
press the play key to confirm. When Follows is selected,
the output relay is active until the event causing it ceases
to be active.
EN | 17
Remote access
Not allowed
Not allowed
Allowed
Allowed