Bosch DVR4C1161 Installation Manual page 18

Bosch dvr4c1161: user guide
Hide thumbs Also See for DVR4C1161:
Table of Contents

Advertisement

DVR4C | Installation Manual | Menu system
>> MONITOR SETUP
>>> DISPLAY CAMERA WITH MOTION
Select if the DVR switches automatically to a full
screen image of the camera when motion is detected
on that camera.
With multiple motion detections shortly after each
other, the last camera where motion was detected is
used for display.
>>> DISPLAY CAMERA WITH INPUT ALARM
Select if the DVR switches automatically to a full
screen image of the camera when an input alarm
becomes active for that camera.
In case of multiple input alarms shortly after each
other, the last input alarm is used for display.
>>> DISPLAY DWELL TIME
Specify the dwell time for displaying the camera
with an input alarm or motion. The interval can be
configured with a slider from 5 to 10 seconds.
If Follows is selected, the camera of the channel in
alarm or with motion is shown for as long as the
alarm is present or motion is detected.
>>> SEQUENCE DWELL TIME
Specify the sequence dwell time that is used when
the SEQ key is pressed.
The interval can be configured with a slider from Off
(disable) to 60 seconds (default 10 seconds).
>>> EXIT PLAYBACK ON EVENT
When set to On, the DVR exits playback to display a
live event.
Bosch Security Systems | Version 1. 1
>> SECURITY
>>> LOCAL PASSWORDS
Set a local user password to allow a user limited
access rights only for monitoring, monitoring control
(Auto Seq., digital zoom), copy and playback
control. Configuration is not allowed.
A password consists of 4 digits (0-9), entered by
using the up and down keys.
To confirm the input, the user has to enter the same
password again.
The configured password is only valid for local
users. The password is shown in the menu using *
characters.
If a password is set, a user without the correct
password can only view live video and switch
between full screen or quad views.
Set a local administrator password. An administrator
is allowed to enter all menus and configure all
settings.
A password consists of 4 digits (0-9), entered by
using the up and down keys.
To confirm the input, the administrator has to enter
the same password again.
The configured password is only valid for the local
administrator. The password is shown in the menu
using * characters.
To lock the keys on the front of the DVR, set keylock
to On and enter a four-digit password. (To unlock all
the keys on the front panel, use Keys 1 to 4 to enter
the password.)
EN | 18

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dvr4c1081Dvr4c

Table of Contents