Specifications - Haussmann Xpert PNT146-R Operator's Manual

IMPORTANT SAFETY INSTRUCTIONS
Use only a pressure-regulated compressed air source to limit the air pressure

supplied to the tool. The regulated pressure must not exceed 110 PSI. If the
regulator fails, the pressure delivered to the tool must not exceed 120 PSI. The
tool could explode which will cause death or serious personal injury.
Always disconnect air resource:

a) before making adjustments.
b) when servicing the tool.
c) when clearing a jam.
d) when tool is not in use.
e) when moving to a different work area, as accidental actuation may occur,
causing injury.
Never connect tool to an air source that may exceed 180 PSI. Over pressurizing

the tool may to result in bursting, abnormal operation, breakage of the tool or
serious injury to persons. Use only clean, dry, regulated compressed air at the
rated pressure or within the rated pressure range as marked on the tool. Always
verify prior to using the tool that the air source has been adjusted to the rated air
pressure or within the rated air-pressure range.

SPECIFICATIONS

The HAUSSMANN XPERT coil nailer is a light duty, pneumatic nailer, using
compressed air as a power source. Ideal for roofing, underlaying, wall sheathing,
framing and recreational decks. High-capacity magazine can fasten a full bundle of
shingles. Lightweight and well balanced for easy operation
Drives 15° wire- collated nails from 0.113" to 0.146" (2.87 - 3.7 mm) in diameter,

1-3/4" to 3-1/2" (45-90mm) in length (Fig.1)
Min.
9/32"
(7 mm)
cal. 9
0,113" (2.87 mm)
Operating pressure: 70 - 110 PSI

Max. Pressure: 120 PSI

Magazine capacity: 225 Nails

Air Inlet: 1/4" (6 mm) NPT

ACCESSORIES
Safety goggles

Air tool oil

4 Hex keys

Carrying case

Max.
9/32"
(7 mm)
cal. 7
0,146" (3.7 mm)
15 o
5/16"
(8.2 mm)
Fig.1
23