Haussmann Xpert PNT146-R Operator's Manual page 25

!
!
Latch
Fig.5
Movable cover
Fig.6
Magazine
Fig.7
movable cover
OPERATING PROCEDURES
CAUTION:
All air line components (including hoses, pipe, connectors, filters, & regulators,

etc.) must be rated for a minimum working pressure of 150 PSI or 150% of the
maximum system pressure, whichever is greater.
Disconnect the tool from the air supply before performing maintenance, clearing a

jammed fastener, leaving the work area, moving the tool to another location, or
handing it to another person.
1. After reading and understanding this entire manual, connect tool to the air
supply.
2. Turn on the air compressor and adjust the regulator to the proper pressure for
the fastener size you are using. (See the Using the Tool section below with
regards to adjusting this.)
CAUTION:
 Keep tool pointed away from yourself and others at all times.
 Always disconnect tool to air supply before loading fasteners.
 Do not load fasteners with trigger or safety pressed.
 Always wear approved safety glasses, and hearing protection when preparing
or operating the tool.
 Never use a tool that leaks air or needs repair.
LOADING FASTENERS
1. Depress magazine latch (A, Fig.5).
2. Open movable cover (Fig.6).
3. Open the magazine cover (Fig 7).
25