Functional Description; Operating Procedures - Haussmann Xpert PNT146-R Operator's Manual

FUNCTIONAL DESCRIPTION

Figure 2 names the major components of the HAUSSMANN XPERT
coil nailer.
A. Air deflector
B. Body
C. Contact tip
D. Magazine
E. Air plug
F. Trigger
G. Trigger mode selector
H. Depth adjustable knob

OPERATING PROCEDURES

SETUP
AIR SOURCE
The HAUSSMANN XPERT coil nailer is designed to operate on clean, dry,

compressed air, regulated at 70-110 PSI. The preferred system would include a
filter, a pressure regulator, and an automatic oiler located as close to the tool as
possible. Within 15 feet (5 m) is ideal. Do not use bottled air or gases. Please see
below (Fig.3):
Coil nailer
All compressed air contains moisture and other contaminants that can harm the

internal components of the tool. An air line filter will remove most of these and
significantly extend the life of the tool. Ensure the in-line oiler has sufficient oil.
If an in-line oiler is not available, place 2 drops of oil into the tool's air inlet at
the beginning of each workday. More than this will be expelled from the tool's
exhaust during firing. (Fig.4)
Air fitting: The nailer/stapler should be equipped with a 1/4" NPT male 'quick

connector'. To prevent accidental cycling even though disconnected, the tool
must always be connected to the air supply in such a way that all air pressure
in it is released when the coupling is disconnected.
24
PNT146-R
Air hose
Quick coupling
A
B
C
Regulator
Oiler Filter
F
G
D
H
Fig.2
Air connector
Fig.3
Fig.4
E