Maintenance - Haussmann Xpert PNT146-R Operator's Manual

OPERATING PROCEDURES
CLEARING A JAMMED FASTENER
!
CAUTION: Disconnect tool from air supply.
1. Open latch.
2. Rotate magazine cover.
3. Remove the nails from the magazine.
4. Use a slender, soft steel rod to drive the drive blade to its uppermost position.
5. Use a pair of needle nose pliers to remove the jammed fastener.
6. Follow instructions in the LOADING FASTENERS section to reload fasteners.
CAUTION:
 Keep the tool pointed away from yourself and others at all times.
 Always disconnect the tool to air supply before loading fasteners.
 Do not load fasteners with safety or trigger depressed.
!
 Always wear approved safety glasses and hearing protection when preparing
or operating this tool.
 Never use a tool that leaks air or needs repair.

MAINTENANCE

CAUTION: Disconnect tool from air supply before cleaning and inspecting the
!
tool.Correct all problems before operating.
CLEAN AND INSPECT DAILY
 Add pneumatic tool oil into the oiler regularly for all moving parts. Frequent,
but not excessive lubrication is required for the best performance. Oil added
through the air line connection will lubricate the inside parts. An automatic
oiler is recommended, but 2 drops of oil may be added manually into the tool's
workday and after about every hour of continuous use. Only a few drops at a
time are necessary. More than this will pool inside the tool and be expelled from
oil with detergents or other additives, as these can cause accelerated wear on
the seals.

and contaminants out of the air tank.
 Wipe the tool clean.

cleaning solutions to wipe exterior of tool if necessary.
 Do not soak tool in cleaning solutions. Such solutions can damage internal
parts. The exposed portion of the small piston rod and feed hook must be kept clean.
 Inspect trigger and safety mechanism daily to ensure system is complete and
functional.
 Keep all screws tight. Loose screws can cause personal injury or damage to the tool.
 Check if there are worn and damaged parts. If any, please replace immediately.
at the beginning of each
27