Haussmann Xpert PNT146-R Operator's Manual page 26

OPERATING PROCEDURES
4. Place a new coil of nails in the magazine (Fig.8).
5. Close magazine cover (Fig.9).
6. Draw the first nails out and position the second nail on to the diver guide (Fig.6).
7. Close the movable cover and latch.
USING THE TOOL
Complete all steps as indicated in PREPARING THE TOOL and LOADING
1. Turn the trigger mode selector (G, Fig, 10) so the tail of selector is down.
2. Hold the contact tip (C, Fig. 2) off the surface..
3. Press the trigger.
4. Keeping the trigger pressed, push the contact tip (C, Fig. 2) of the safety bracket
against the working surface. Once the bracket is pushed back enough, the nail
CAUTION:
 Disconnect tool from air supply before performing maintenance, clearing a
jammed fastener, leaving working area, moving tool to another location or
handing the tool to another person.
 Clean and inspect tool daily. Carefully check for proper operation of trigger
and safety mechanism.
 Do not use the tool unless both the trigger and the safety mechanism are functional.
 Do not use the tool if its leaking air or needs any other repair.
LOCK OFF THE TOOL
When turning the trigger mode selector (G, Fig.10) and the tail of selector is up, the
firing mechanism is locked off.
FASTENER DEPTH
Driving depth can be adjusted by rotating the depth adjustment knob (H, Fig.11).
1.
2. If the nail is driven too deep, rotate the knob clockwise (when tool is upside-
down) to move the safety bracket downward.
3. If a greater depth is desired, rotate the knob counter clockwise to adjust the
safety bracket upward.
4.
5. REPEAT AS NECESSARY UNTIL DESIRED DEPTH IS ACHIEVED. The
amount of air pressure required will vary depending on the size of the setting.
6. Determine the lowest setting that will consistently perform the job at hand.
Excessive air pressure may cause premature wear and/or damage to the tool.
26
PNT146-R
This tool uses the "bump fire" firing mode:
Fig.8
Fig.9
G
Fig.10
!
H
Fig.11