Makita BFT040F Technical Information page 14

W
iring diagram
Wiring in housing (12V model BFT123F)
Put the following lead
wires out of housing.
* Controller lead wires
(gray and blue) for
connecting to LED
circuit
* Controller lead wires
(purple and yellow) for
connecting to switch
unit
LED circuit
Pass the following lead wires
between rib and the wall of
housing.
* Terminal lead wires
(black and red)
* Buzzer circuit lead wires
(white and red)
The connector has to be put
on the terminal side of this line
as illustrated.
1
Refer to the wiring on the
switch unit in detail
on the next page.
Switch unit
Switch
Rib
Buzzer circuit has to be so mounted,
that the sponge side is faced to the
housing L side.
Pass the endbell lead wires (black and
red) both sides of LED cover portion
of controller.
Endbell lead
wire (red)
2
Refer to the wiring on the
switch in detail on the next
page.
Controller
Connector
Buzzer
circuit
Terminal
P 14 / 15
Endbell
lead wire
(black)
LED cover
portion
Rib
Pass the following lead wires
between the ribs of switch.
* Controller's lead wires (white
and orange) to be connected
to micro switch.
* Controller's lead wires (blue,
purple and white) to be
connected to reverse switch.
* Controller's lead wires (red
and white) to be connected
to buzzer circuit.
Pay attention, not to pinch the
above lead wires between switch
and housing.