Viavi T-BERD 5800 Quick Card page 2

Launch Test:
1. Press the Power button
test set and view the startup screen.
2. Using the Select Test menu, Quick Launch
menu, or Job Manager, launch an Ethernet
test on Port 1 as follows:
• Ethernet►10/100/1000►
Layer 2 Traffic►Dual Thru
3. Tap to display the T-BERD's Tools
Panel. Tap
to continue.
Configure Test:
1. Tap the Port Selection soft key
select Port 1.
2. Press the Setup soft key
3. In the Filters/Ethernet settings, set desired
encapsulation, MAC Address filter (DA or
SA), VLAN filter, or Type filter for Port 1.
4. Tap the Port Selection soft key
select Port 2.
In the Filters/Ethernet settings, set desired
5.
encapsulation, MAC Address filter (DA or
SA), VLAN filter, or Type filter for Port 2.
6. Press the Results soft key
the Results screen.
7. Press the Restart Soft Key
side of the screen.
8. Check LEDs: Green Sync Acquired and Link
Active LEDs indicate that the T-BERD has
successfully connected to the network
equipment.
9. Set the left Results Window to display
Port 1/Ethernet/Capture results.
10. Set the right Results Window to display
Port 2/Ethernet/Capture results.
to turn on the
and press
to
.
to
to return to
on the right
Figure 3: Launch Test
Figure 4: Reset Test to Defaults
Figure 5: Setup
Figure 6: Check LEDs and Set Results Windows