Bosch Rexroth LTS350D Instructions Manual page 19

3 608 870 0D6/2011-12 | LTS350D/LTE350D
Personnel qualifications
Assembly, commissioning and operation, dis-
assembly, service (including maintenance
and repair) require basic electrical and me-
chanical knowledge, as well as knowledge of
the appropriate technical terms. In order to
ensure operating safety, these activities may
therefore only be carried out by qualified
technical personnel or an instructed person
under the direction and supervision of quali-
fied personnel.
Qualified personnel are those who can rec-
ognize possible hazards and institute the ap-
propriate safety measures due to their
professional training, knowledge, and experi-
ence as well as their understanding of the rel-
evant conditions pertaining to the work to be
done. Qualified personnel must observe the
rules relevant to the subject area.
Safety instructions in this docu-
ment
In this manual, there are safety instructions
before the steps whenever there is a danger
of personal injury or damage to the equip-
ment. The measures described to avoid these
hazards must be observed.
Safety instructions are set out as follows:
SIGNAL WORD
Type of RISK!
Consequences
Precautions
• Safety sign (warning triangle): draws at-
tention to the risk
• Signal word: identifies the degree of haz-
ard
• Type of risk: identifies the type or source
of the hazard
• Consequences: describes what occurs
when the safety instructions are not com-
plied with
• Precautions: states how the hazard can
be avoided
Bosch Rexroth AG
This warning symbol cautions
against dangers to your health.
Observe all the safety instructions
that follow this symbol to avoid
possible injuries or death.
This warning symbol cautions
against dangers to your health
caused by electrical voltage or
currents. Observe all the safety in-
structions that follow this symbol
to avoid possible injuries or death.
CAUTION
CAUTION indicates a potentially ha-
zardous situation which, if not avoided,
could result in minor or moderate injury or
damage to equipment.
If this information is disregarded,
the operating procedure may be
impaired.
Adhere to the following instruc-
tions
General instructions
Only accessories and add-on units that have
been approved for use in Rexroth tightening
systems may be used therein. Non-approved
components may neither be added nor con-
nected to the system. The same applies to
cables and lines which belong to the Rexroth
tightening system. Otherwise, functional and
system safety is jeopardized.
Observe the regulations for accident preven-
tion and environmental protection for the
country where the product is used and at the
workplace.
Exclusively use Rexroth products in good
technical order and condition.
19/88