General MMD900 User Manual page 8

way by simultaneously pressing the
at least three seconds. Doing this will cause the beeper to sound, the backlight
to come on and the word "SEtUP" to scroll across the LCD.
After a few seconds, the LCD will read out "0 = 0". In this format, the left digit
represents the Option No. and the right digit stands for the current setting for
that option. For example, "0 = 0" is shorthand for Option 0, Setting 0.
The table below details the five function options available to you in Setup
mode.
Function Option No.
(Left Digit) (Right Digit)
Default 0
Settings
Source
Beeper 1
Auto power 2
off
Backlight 3
Calibration 4
Check
The factory default setting for all five functions—including the source of the
default settings—is 0.
To change any or all settings to your choice(s), you must first change the
setting of Option 0 from 0 to 1. Opportunities to change the settings of the other
four functions from their factory defaults are then made available in order, from
Option 0 to Option 4. As each Option is presented, you can change its setting or
leave the existing setting unchanged. In either case, you must confirm (save)
8
and Mode buttons and holding them for
Setting Action
0 Loads factory default settings
1 Loads user's default settings
Backlight comes on for 30 seconds
0 Programs beeper to beep faster the higher the
moisture level above 17%WME (17 in REL mode)
1 Programs beeper to beep faster the higher the
moisture level
2 Programs beeper to sound when switching
between measurement modes
3 Disables beeper. Removes
0 Disables auto power off function
1 Sets auto power off interval to 3 minutes
2 Sets auto power off interval to 5 minutes
3 Sets auto power off interval to 10 minutes
0 Disables display backlight
1 Enables display backlight
0 Enables manual calibration checking by user
1 Programs meter automatically check calibration
following power on
icon from display