Aquatec® KOGIA
7.
Hold the backrest at the center of the head end while
slightly pushing down the actuator fixation at the same
time and carefully lift the backrest into the end position.
8.
Hold the charged battery B on handle A and insert it
from above into guide C of the backrest.
9. Push the battery completely down.
The battery should click into place.
The bath lift is now ready for use.
14
Fig. 4-7
Fig. 4-8
Risk of Damage
– Make sure that the backrest does not touch
the bathtub edge.
– Place the bath lift further forwards in the
bathtub, if necessary. To place the bath lift
further forwards in the bathtub lower the bath
lift to the bottom, loosen the suction cups and
then move the bath lift.
4.3 Charging Battery
The bath lift cannot be used when the battery is charging.
WARNING!
Risk of Electric Shock
– Only recharge the battery in dry rooms at room
temperature (15 °C to 25 °C) and never in the
bathroom.
Risk of Damage
– Only use the supplied charger to charge the
battery.
– Only connect the charger to the mains supply
when the battery is connected to the charger.
– Make sure that the voltage specifications
shown on the charger correspond to those of
the mains supply.
1584939-B