HOBBYEAGLE A3 PRO V2 User Manual page 4

your radio transmits the channels in the correct order. If this is not the case, you have to change the
channel mapping in the Receiver Menu. If you use a standard PWM receiver with standard wiring layout
the channel mapping does not apply. When A3 Pro V2 is operating in single line receiver mode, the [THR
Out/AIL] can be used as the throttle output channel for the ESC or the throttle servo if a mini receiver is
being used which has no additional output connectors.
Serial Receiver Protocols Supported:
 PPM Receiver
 Futaba S.Bus (compatible with FrSky SBUS, RadioLink
SBUS and WFLY WBUS)
 Spektrum DSM/DSMX 1024 Satellite Receiver
 Spektrum DSM/DSMX 2048 Satellite Receiver
 Spektrum SRXL
 Multiplex SRXL / JR XBUS Mode B
 Graupner SUMD
 FlySky iBus
NOTES
 Please note that the remote master gain channel is disabled in single line mode as default.
Assign a channel number for gain channel in Receiver Menu to activate this feature if needed.
 Pay attention to the polarity of the plugs. The orange signal line must always be on the top and
the brown on the bottom.
 You will need to purchase an optional adapter if you are using a Spektrum satellite receiver.
WWW.HOBBYEAGLE.COM
Default Channel Mapping
Function Channel Assignment
Aileron Channel 1
Elevator Channel 2
Throttle Channel 3
Rudder Channel 4
Flight Mode Channel 5
Master Gain None
4 / 15