HOBBYEAGLE A3 PRO V2 User Manual page 14

Receiver Menu Table
Functions
LED Status
Receiver Type
1
Violet, 1 flash
2
Aileron Channel
Violet, 2 flashes
Elevator Channel
3
Violet, 3 flashes
Rudder Channel
4
Violet, 4 flashes
Mode Channel
5
Violet, 5 flashes
Gain Channel
6
Violet, 6 flashes
Throttle Channel
7
Violet, 7 flashes
DSM Bind Option
8
Violet, 8 flashes
ACCELEROMETER CALIBRATION
Before leaving the factory every unit has been carefully tested and calibrated. Usually you do not need
to perform a calibration of the accelerometer during use. However, in some specific cases, we would
suggest you re-calibrate the accelerometer to obtain better performance, these include temperature
changes those will probably cause the mechanical characteristics changes of the sensor, or replacement
of new sensor, etc. The calibration should be done on a horizontal desktop and the gyro needs to be
removed from the airplane.
Entering the Calibration Program
To access the accelerometer calibration program, press and hold the button while turn on the power of
the gyro, release it when LED starts flash Violet slowly. (FYA: Do not release the button when LED turns
solid Violet yet, or you will get into the Receiver Menu but not the accelerometer calibration program.)
WWW.HOBBYEAGLE.COM
Solid Solid Solid
Red Green Blue
Standard* PPM SBUS
None CH1* CH2
None CH1 CH2*
None CH1 CH2
None CH1 CH2
None* CH1 CH2
None CH1 CH2
None* DSM2 DSMX
( is the default setting)
*
Solid Solid Solid
Yellow White Violet
DSM2/X DSM2/X Spektrum
1024 2048 SRXL
CH3 CH4 CH5
CH3 CH4 CH5
CH3 CH4* CH5
CH3 CH4 CH5*
CH3 CH4 CH5
CH3* CH4 CH5
Red Green Blue
Flashing Flashing Flashing
MPX
SUMD IBUS
SRXL
CH6 CH7 CH8
CH6 CH7 CH8
CH6 CH7 CH8
CH6 CH7 CH8
CH6 CH7 CH8
CH6 CH7 CH8
14 / 15